HOW TO REPLACE THE HEAD OF YOUR KOKIDO POOL ROBOT CLEANER DELTA 100 & 200

HOW TO REPLACE THE HEAD OF YOUR KOKIDO POOL ROBOT CLEANER DELTA 100 & 200

1st Rule when you do maintenance on your Pool Robot Kokido Delta 100 or 200! [Easy and can be done in 2min]

Why do you want to remove the Head Swivel? 

For Cleaning?

The robot has a water-propelling nozzle at the bottom of the swivel head, and you need to clean it well to ensure not leave, or any blocking happens after multiples used of it. A good cleaning will guarantee you a long life of your robot.

Or Replacement?

For some reason, the swivel head needs to be replaced after a long time of using it (usually every 2 to 4 years) depending on the used (Daily/Weekly/Monthly).

 

Do not forget to guarantee a long life of your Kokido Robotic Pool Cleaner:

  1. Be sure to clean and dry the areas around the charging port and water sensors after every use to avoid the forming of stains ( Can be removed by light scrubbing with a cotton bud soaked with juice of lemon or vinegar.)
  2. The battery discharges on its own during storage. Make sure to fully charge the robot before storage. (recharge the battery once every three months when it is not in use.
  3. If necessary, rinse the robot and accessories with fresh water. DO NOT use detergent.
  4. Be sure to drain the water from the robot before storage. Use a damp cloth to clean and dry the robot and its accessories.

     For any Intex or Bestway above-ground Swimming Pool, Spa, kiddies Pool, the Kokido products is just what you need,

    Post a comment

    Please note, comments must be approved before they are published